PIN220-YM0EST AIRE 220 YM – Plug-In Electronic Protector for Air Conditioners and Refrigeration Equipment, with Adjustable Cut-off Voltages and ON-OFF switch, 220VAC 20A NEMA 10-20 (Spanish Edition)

The BREAKERMATIC Aire 220 YM is an electronic voltage protector specially designed to prevent damage to your air conditioning equipment caused by a blackout or high or low voltage. It is ideal for equipment equipped with a cord plug, making it easy to install the protection without disturbing the equipment.

The BREAKERMATIC Aire 220 YM will disconnect your equipment in the event of a power failure and will keep it off for the duration of the failure and for the time necessary to equalize the pressures in the cooling system. It will then automatically reconnect your equipment.

The BREAKERMATIC Aire 220 YM includes knobs that allow you to adjust the high and low cut-off voltages, allowing you to better adapt it to the electrical conditions of your location. It also includes a power on/off button.

Easy to install and guaranteed protection 24 hours a day! Connect your equipment's plug or socket to the BREAKERMATIC Aire 220 YM, and then directly to the wall outlet.

In addition to air conditioning equipment, this protector can be used on any commercial refrigeration equipment equipped with a cord plug. Its robust construction and high capacity make it ideal for heavy-duty applications.

Ideal for

• Single-phase mini-split air conditioners up to 20A
• Single-phase refrigeration equipment up to 2 HP
• Window air conditioners up to 20A
• Freezers
• Display cabinets, coolers, among others.

Connection and capacity

The BREAKERMATIC AIRE 220 YM can operate any equipment with a plug NEMA 10-20,  compatible with the protector's NEMA 10-20 outlet. The use of external adapters is not recommended. You must also connect it to a wall outlet NEMA 10-20 compatible with the protector's plug to ensure sufficient current capacity.

Operation

Protection against steady-state voltage variations

The BREAKERMATIC AIRE 220 YM disconnects the output if the steady-state voltage is higher than the high cut-off voltage or lower than the low cut-off voltage, set using the adjustment knobs on the rear of the protector. Cut-off voltages can be set within the ranges indicated in the specifications. The response time to a fault is typically 1 s. The voltage must remain outside the range for longer than the response time for the disconnection to be activated. While the fault persists, the corresponding high or low voltage indicator will remain illuminated.

Reconnection delay or standby cycle

When the protector is energized, or at the end of a voltage failure, the protector will initiate a time delay before connecting the output. The duration of the time delay is indicated in the specifications. The standby cycle protects sensitive equipment from short operating cycles, allowing, in the case of A/C and refrigeration equipment, system pressures to equalize before reconnecting.

Autostart ®.

This feature reduces the standby cycle to 5 seconds when the protector has been off for a considerable amount of time.

Detection of blackouts and  sags

The protector will disconnect the load if it detects a sudden voltage drop below 50% of the nominal voltage and will initiate a standby cycle.