We use quality-proved raw material provided by world-famous suppliers such as National Semiconductor, SGS Thomson, Motorola, Original Relay from Japan, and Song-Chuan from Taiwan. We also adquire our resources importing directly from the country of origin. That’s why BREAKERMATIC has its customers’ trust.

The electric protectors constantly monitore the line’s voltage level. According to the reading it does, it activates or disactivates the equipment’s feed protecting it from the listed drops. When voltage failures or blackouts occur, the protector delays the refrigerator’s start allowing the refrigerating gas’ pressures to stabilize, so that the compressor starts with a minimum effort. This way, it is assured that the compressor starts and works with the right voltage and current according to its specifications.

Our Electric Protectors reduce the problems that are caused by irregular voltage feed increasing the equipment’s productivity, decreasing costs, and extending their lifetime.

A voltage protector is different from a pick’s suppresor. The last one only eliminates spikes, transitory changes of a very short duration that frecuently appear in the electric distribution lines and don’t offer protection against stationary variations of the line tension or momentary fluctuacions.

It’s important to know that a voltage protector is not a regulator. Voltage protectors only check if the electrical line send the right tensions, but they haven’t been designed to correct irregularities in the electricity source. That’s why protectors are much more affordable than regulators and stabilizers. A regulator or stabilizer works increasing or reducing the tensions automatically guaranteeing that the output keeps within the load’s operation range. However, the use of a regulator is only recommended when the tension level are over the maximum accepted range, that is, when their duration is over 20% of the working time.

It’s an affordable device that protects artifacts from variations and interruptions of voltage feed.

We have the Just in Time (JIT) system. This continuous-flow system allows us, in the first place, to change the model of the products to manufacture in a matter of minutes to adequate the demand’s variations. In the second place, since there’s no products’ storage, we detect eventual failures and fix them at once. In the third place, we have a quality control of all of our products in two consecutives stages: on the electronic circuitry before being packed and the final product once concluded.

Because the electricity service is irregular in many countries. This means, the voltage feed can be above or below the nominal voltage equipments need, and this affects their performance and durability. The greatest danger of these variations is the fact that they’re not perceptible, and users may think their artifacts are working properly and are being fed with just the right voltage, when they are in risk. Another inconvenient which frequently occurs is the blackout which consists of a sudden power cut that considerably affects equipments.